TRAINING
At Lingl UK we understand that even the very best machines, equipment and systems will only ever be optimised if the operators and engineers running and maintaining them are fully trained.
Together with our sub-suppliers, we run a wide range of on-site training including courses on Pneumatics and Hydraulics, Simatic S7, Drive and Control Technology and Robotics.
Pneumatics and Hydraulics
This course is intended for maintenance personnel, shift leaders and machine operators with good basic technical knowledge.
Course Content
Pneumatics
- Basics of gas laws, units and compressed air
- Presentation of components
- Compressed air stations / distribution networks
Hydraulics
- Basics of pumps and drive motors
- Presentation of components
- Circuit diagrams, symbols, circuits
- Manufacture and installation of hydraulic piping systems
- Rating of hydraulic cylinders
Simatic S7
This course is intended for company electricians, maintenance personnel and shift leaders with a basic understanding of Windows and programming
Course Content
- Introduction to the S7-400
- Programming STEP 7
- Presentation of components
- Introduction to programming techniques
- Working with the test functions
- Documentation
- Fault diagnostics
- Introduction to the machine operation and visualisation system
Drive and Control Technology
This course is intended for company electricians, maintenance personnel and shift leaders with a basic knowledge of Windows XP
Course Content
- Introduction to drive technology
- Frequency converters (FUs)
- Servo-inverters
- Positioning control
- Setting of variable-speed drives
- Data saving / archiving
- Troubleshooting
- Replacement of equipment
Robotics
This course is intended for shift leaders, company electricians, machine operators and maintenance personnel with a basic knowledge of Windows XP
Course Content
- Hardware
- Basics of programming
- Programme structure
- Data transmission
- Coordination systems
- Position correction using operating system
- Matrix Programming System (MPS)
- Working with manual control unit
- Fault diagnostics
- Troubleshooting
- Connection/interface to the machine operation and visualisation system
